STLINK V2 100% compatible JTAG SWIM programmer debugger STM8/STM32

Brand: Bravekit
Product Code: ST-LINK_V2
Availability: In Stock
Price:
$19.00

Qty: - +
   - OR -   

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 2500 VRMS.
STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software.
STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

Features:

  • 5 V power supplied by a USB connector
  • true schematic and firmware 100% identical to STLINK/V2
  • USB 2.0 full speed compatible interface
  • mini USB connector
  • can supply target board via SWIM ir JTAG cable with 3V3
  • SWIM specific features1.65 V to 5.5 V application voltage supported on SWIM interface
  • SWIM low-speed and high-speed modes supported
  • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
  • JTAG/serial wire debugging (SWD) specific features1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs
  • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
  • SWD and serial wire viewer (SWV) communication supported
  • Direct firmware update feature supported (DFU)
  • Status LED which blinks during communication with the PC
  • small size

This programmer is 100% identical to original STLINK/V2 programmer. It uses mirrored SWIM cable (as original STLINK/V2)

STM8S-DIP-LQFP48 модуль

 

Documentation:

 

What included:

  • STLINK/V2 programmer
  • 20 pin JTAG cable

Write a review


Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: