STM32F103-DB 128k/512k board for ST CORTEX-M3 controllers
Price: $59.95
Development board STM32F103-DB is a universal tool to explore new ARM CORTEX-M3 microcontrollers from ST Microelectronics.
As a option (not in standard set), character LCD or 2.8''color TFT LCD 262k color screen with 320x240 pixel touch screen can be added to the board.
Board features:
- MCU: STM32F103RBT6 ARM 32 bit CORTEX M3™ with 128K Bytes Program Flash, 20K Bytes RAM, USB, CAN, x2 I2C, x2 ADC 12 bit, x3 UART, x2 SPI, x3 TIMERS, up to 72Mhz operation
- as option can be installed STM32F103RET6 ARM 32 bit CORTEX M3™ with 512K Bytes Program Flash, 64K Bytes RAM
- Large set of jumpers for flexible setup and configuration of board
- USB interface with programmable pull-resistor 1.5 KOhms on the line D +
- standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
- CAN driver and connector
- RS232 driver and connector
- USB/UART converter based on FT232RL from FTDI, connected to USART1. Firmware can be loaded to microcontroller via this USB/UART port with ST Flash Loader Demonstrator software. Extension headers for all port pins of FT232RL.
- UEXT connector which allow different modules with USART, I2C or SPI to be connected
- SD connector with “write protect” and “card inserted” detection
- backup battery connector
- RESET button
- power supply LED (red)
- two status LED’s
- on board voltage regulator 3.3V with up to 800mA current
- Wide range of power supply inputs:
- Connected to ADC potentiometer
- 8 MHz crystal oscillator
- 32768 Hz crystal and RTC backup battery connector
- “Wakeup” button, “Tamper” button and two user buttons
- 16K 25LC160A EEPROM with SPI interface
- Ability to connect a standard character LCD with HD44780 controller (WH2002 type, etc.) with the choice of its supply voltage (3.3 V/5V) and adjustable contrast
- Connector for color 2.8 "TFT LCD Display 320 * 240 pixels 262K color touch-screen module. The board provides a fully functional operation of the display via 8-bit bus, and the work of touch panel with control on the SPI.
- extension headers for all uC ports
- PCB: FR-4, 1.5 mm (0,062"), solder mask, silkscreen component print
- Dimensions: 123 x 91mm (4.85 x 3.5")
Documentation:
Software:
- STM32F103-DB examples for Keil µVision. Al examples are tested with STM32F103-DB board
- "Flash loader demonstrator" software for loading firmware to board via USB2
What included:
- One STM32F103-DB board
- PLEASE NOTE!! 2.8" TFT LCD module not included. It is can be added as option
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
