AVR-IO board with 4 optoisolated inputs and 4 relay outputs AVR IO
Price: $28.00
Development board for 20 pin AVR microcontrollers (such as ATMEL ATtiny2313, AT90S2313, AT90S1200) with power supply circuit, crystal oscillator circuit, RS232 port, ISP port, 4 relays output, 4 optocoupler isolated inputs. This board can be used as ready part of you " Smart House system" or for your development project with ATMEL AVR controller. Board fully assembled and tested.
Features
- ICSP 5x2 pin connector for in-circuit programming with AVR ISP, AVR ISP v3.2 or any other ISP programmer
- DIL20 microcontroller socket
- status LED connected to PB4
- reset circuit MC34064
- Quartz crystall oscilator circuit 7.3728 MHz
- Voltage regulator +5V, 78L05 and filtering capacitors
- Power plug-in jack
- RS232 DB9 female connector , RS232 MAX232 interface circuit with Tx, Rx signals
- 4 optocoupler isolated inputs with screw terminals
- input status LEDs
- 4 relay outputs with 10A/250VAC contacts with screw terminals
- output status LEDs
- four mounting holes 3.3 mm (0.13")
- FR-4, 1.5 mm (0.062"), green soldermask, white silkscreen component print
- dimensions 80.5x75 mm (3.17 x 2.95")
Links
- Schem for AVR-I/O board
- Dimensions of AVR-IO board
- ATtiny2313 HEX test firmware for testing relay outputs and RS232. This firmware with interval 1.5 sec TURN ON and TURN OFF each relay output and send on RS232 (9600 baud, 8 bit, 1 bit stop) information about what RELAY output is enabled&disabled at this moment ( quartz crystal 7.3728MHz must be installed on board for correct working of RS232)
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
