Blank PIC-P28 prototype board for 28-pin PIC controllers

With this board you can develop and prototype with any of Microchip's 28 pin PIC microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware. The board have User button and status LED. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters. PIC-P28 supports both 3.3V low power and normal 5V operation.

As option can be added PIC microcontroller

Features

1. ICSP/ICD connector for programming with any PIC programmer or debugging (EXTRA-PIC, JDM PIC, ICD2, PICkit2 or other),
2. RS232 Tx, Rx interface with MAX232 IC
3. DIL28 microcontroller socket
4. Quartz crystall 20Mhz
5. LED to RA0 through jumper
6. user Button on RA5 port
7. Reset button
8. Power plug-in jack
9. selectable +3.3V / +5V power supply voltage regulator
10. Extension slot on every uC pin
11. Gird 100 mils (2,54mm)
12. GND bus
13. Vcc bus
14. Four mounting holes 3 mm (0,13")
15. FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print .
16. Dimensions 100x80 mm (3,9x3,15")

Documentation

• PIC-P28 electrical schem
• PIC-P28 component placement, top side
• PIC-P28 component placement, top side

Software

• Blinking LED PIC16F876 demo code (C source and HEX)
• Button PIC16F876 demo code ( C source and HEX)
• RS232 receive/transmitt PIC16F876 demo code (C source and HEX)

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: